Installation guide

6-11
SNMP Access Problems
Authentication Failure TRAP Messages Not
Reported
Solution
If you suspect a network management station (NMS) is not receiving authentication
failure TRAP messages from the access server, enter the following command:
Local> SHOW SNMP
SNMP State: Enabled Authentication Failure: Enabled
Community Name Address GET GETNEXT SET TRAP
PUBLIC ANY ENA ENA DIS DIS
SECRET 60.10.12.61 ENA ENA DIS ENA
• Verify that Authentication Failure is Enabled. If it is not, enter the following command:
Local> CHANGE SNMP AUTHENTICATION FAILURE ENABLED
• Verify that SNMP State is Enabled. See the section Verify SNMP Enabled
(page 6-4).
• Verify that the community is configured with TRAP messages enabled. See the section
Access Server Not Responding with the Requested MIB Information (page 6-7).