Switch User's Guide

General Configuration Using Local Management
CSX400 and CSX400-DC User’s Guide 171
To enable RIP Routing, complete the following steps:
1. From the IPX Configuration screen, highlight IPX RIP and then press ENTER.
The IPX RIP Configuration screen, shown in Figure 72, displays.
2. Use the arrow keys to highlight the Port option.
3. Type in the number of the port that you wish to enable RIP routing and then press ENTER.
4. Use the arrow keys to highlight the Port Level RIP option.
5. Use the ENTER key to toggle the entry to ENABLED.
6. Use the arrow keys to highlight the SAVE command field at the bottom of the screen, and then
press ENTER. The message “SAVED OK” displays.
Figure 72 IPX RIP Configuration Screen
System Level RIP:
Port Level RIP:
RETURN
SAVE+PORT-
DISABLED
DISABLED
IPX Address: xxx.xxx.xxx.xxx
Port: 1
CSX400 Local Management Flash Image Version XX.XX.XX
IPX RIP CONFIGURATION