Switch User's Guide
Troubleshooting
CSX400 and CSX400-DC User’s Guide 215
User Cannot Communicate with Remote Network Station
If Bridging,
• Check that the Bridging Default Destination is set.
• Check that bridging to/from the remote router is set on.
• Be sure to reboot if you have made any bridging destination or control changes.
If TCP/IP Routing,
• Check that TCP/IP Routing is set on and is enabled at the remote end.
• Check that the IP address of the LAN beyond the remote router is correct, as well as the
associated Subnet Mask.
• If the remote router WAN IP address and Subnet Mask are required, check that they have been
specified correctly.
• Check that, if required, the source and remote WAN IP addresses are on the subnetwork.
• Check that you have seeded the routing table, if RIP is not allowed to flow on the WAN link.
• Be sure to reboot if you have made any IP address, control or protocol option changes.