Switch User's Guide

CSX400 Configuration with QuickSET
78 CSX400 and CSX400-DC User’s Guide
The following definitions explain the fields in the System Passwords window shown in Figure 26.
Read Only Access — This access level allows reading of device parameters not including
system passwords. Place the cursor in this field and type the new system password. Retype the
system password in the Confirm Password field below the Read Only Access field.
Read/Write Access — This access level allows editing of some device configuration parameters
not including changing system passwords. Place the cursor in this field and type the new system
password. Retype the system password in the Confirm Password field below the Read/Write
Access field.
QuickSET (SuperUser) — This access level allows full management privileges. Place the cursor
in this field and type the new system password. Retype the system password in the Confirm
Password field below the QuickSET (SuperUser) field.
When finished configuring the CSX400 system passwords, click on the O
K button in the System
Passwords window to return to the Ethernet 1 and 2 configuration window.
Once your Ethernet configuration is complete, click on the Next>> button and go to the Wide
Area 1 and 2 Configuration section.
!
CAUTION
If you edit the SuperUser system password, be certain not to forget it. If you do, you
cannot perform management functions without returning the device to its factory default
configuration. This effectively erases any configuration work you may have done.