Switch User's Guide

CSX400 Configuration with QuickSET

CSX400 and CSX400-DC User’s Guide 79

Wide Area 1 and 2 Conﬁguration

Refer to the appropriate section listed below to conﬁgure your Wide Area 1 or 2 interface on the

CSX400:

Wide Area T1 Configuration Window

Wide Area E1 Configuration Window

Wide Area DI Configuration Window

Wide Area Synchronous Configuration Window

Wide Area DDS Configuration Window

Wide Area HDSL Configuration Window

NOTE

When conﬁguring WAN interfaces 1 and 2 with

QuickSET

, the Wide Area conﬁguration

window that displays corresponds to the speciﬁc WPIM that is installed into the

CSX400.

NOTE

Conﬁguration for the Wide Area 2 interface is the same as the conﬁguration for the

Wide Area 1 interface.

Both Wide Area 1 and Wide Area 2 slots must be populated to initiate Wide Area

interface 2 conﬁguration.