Specifications

Device Management Page 26 SmartSwitch Router/X-Pedition Switch Router
Application Views Supported Applications
Connector Type
Displays the type of port connector being used.
IF Index
Displays the entry in the MIB-ll Interface Table
corresponding to this port.
Environment View
Access: From the Icon Subviews menu for the
SSR_ChasApp Application icon, select Environment.
This view provides information about the
conditions of the chassis, such as power supply
operation, and fan operation.
Chassis ID
Displays the unique identification number for this
chassis.
Num Slots
Displays the total number of slots for this chassis.
Last Hot Swap
The time the module was last hot swapped.
Fan
Indicates whether or not the fan is functioning.
Temperature
Indicates whether or not temperature control is
functioning.
CM Backup State
Indicates status of the backup Control Module.
Switch Fabric
If a redundant switch fabric is employed, this icon
indicates which is primary and which is backup.
The Administrator can set up an Alarm Watch on
the switch fabrics to activate if either device fails.
To do this:
1 Select device, then from device menu select
Utilities> Watch Manager.
Note that the selected model is highlighted on the
left, and three watches are shown on the right.
FabricStatewatch is shown as inactive.
2 Highlight FabricStatewatch and select
Activate.
Regardless of which Control Module
happens to be Primary, the
Administrator can set up an Alarm
Watch to be notified of the failure of
the backup module. Select the device,
then from the device menu select
Utilities > Watch Manager. Highlight
BackupCMwatch and make the watch
Active.
The selected watch will now
enter the Initial watch status.