Specifications

Device Management Page 27 SmartSwitch Router/X-Pedition Switch Router
Application Views Supported Applications
The selected watch will now enter the Initial
watch status.
Any change in the watched attributes, which are
polled at the device model polling interval, will
now trigger the appropriate watch, with
corresponding event and alarm information. The
alarm will be cleared should the watched
attribute return to its expected value. Note that
the SpectroSERVER would need to be restarted to
recognize existing bad values.
Alternatively the watch editor can be used to
change the watch properties from ByIMT to By
Polling, setting the watch poll period to an
appropriate interval and activating the watch.
Now an alarm will be generated at each watch poll
period if the value is not as expected.
Control Module
Status of the shelf/chassis Active Control
Module’s four LED displays.
PSU Status
Displays the status of each of the power supplies.
An Alarm Watch is applied to the power supplies
by default and the Administrator is notified at the
failure of either Primary or Secondary PSU.
Service Status View
Access: From the Icon Subviews menu for the
SSR_ChasApp Application icon, select Service Status.
This view provides status of the routing protocols
such as; RIP, OSPF, and BGP, and multicast
protocols such as; IGMP, DVMRP, and PIM.
RIP
Displays the current status of RIP in the switch.
OSPF
Displays the current status of OSPF in the switch.
BGP
Displays the current status of BGP in the switch.
DVMRP
Displays the current status of DVMRP in the
switch.
IPX SAP
Displays the current status of IPX SAP in the
switch.
IPX RIP
Displays the current status of IPX RIP in the
switch.
LFAP
Displays the current status of the LFAP in the
switch.