Specifications

Device Management Page 40 SmartSwitch Router/X-Pedition Switch Router
Configuration Views SmartSwitch Router Configuration View
Setting this button to Enabled will cause
SPECTRUM to display a redundant address from
the Redundant Preferred Address list when the
primary address is not accessible.
Setting this button to True will cause SPECTRUM
to monitor the number of interfaces for this
device. If a change is detected by SPECTRUM, the
interfaces displayed in SPECTRUM will be
updated to reflect the change.
Setting this button to True will cause SPECTRUM
to verify the interfaces displayed when a LINK UP
or LINK DOWN event is received.
Setting this button to True will cause SPECTRUM
to verify the interfaces displayed after a model
reconfiguration occurs.
Setting this button to True will cause SPECTRUM
to generate an alarm when a redundant address
has been selected.
Setting this button to True will cause SPECTRUM
to display sub-interfaces in the DevTop view when
RFC1573 is supported by the device.
Setting this button to True will cause SPECTRUM
to relocate the model for this device to a different
topological location as part of AutoDiscovery.
Clicking this button will display a window that
allows you to read definitions for the buttons
included in the Redundancy and Model
Reconfiguration Options view.
Redundancy
Administrative Status
Automatically
Reconfigure Interfaces
Reconfigure due to LINK
UP/Down events
Device Discovery after
Reconfiguration
Generate Redundancy
Alarms
Create Sub Interfaces
Topologically Relocate
the Model
Button Explanations