Specifications

9032231 E1 Event and Alarm Messages
4-13
CyberSWITCH 200 Series and 400 Events and Alarms
CsEvFormat/Event000d013b
{d “%w- %d %m-, %Y - %T”} Alternate
Path Repeater Management has
activated for {m} of type {t} Network
Address changed from {O 1} to {O 2}. -
(event [{e}])
CsPCause/Prob000d013b
ALTERNATE PATH REPEATER
MANAGEMENT ACTIVATED
PROBABLE CAUSE:
Router Redundancy for the managing
device model has probably activated.
RECOMMENDED ACTIONS:
1) Refer to event log for current IP address
used for modeling.
2) Check the subnet and address that was
previously being used to model the
associated device.
CsEvFormat/Event000d1139
{d “%w- %d %m-, %Y - %T”} - Port
Security Status is {T SecureState 3}
for port #{I 2}, located in port group
#{I 1} of {m} ({t}). (event [{e}])
CsPCause/Prob000d1139
Secured State Change
This alarm is generated when the status of
the secure state changes for a specific port.
CsEvFormat/Event000d113a
{d “%w- %d %m-, %Y - %T”} - Network
Learning Status is {T LearnState 2}
for the network interface #{I 1} of {m}
({t}). (event [{e}])
CsPCause/Prob000d113a
Network Learn State
This alarm is generated when network
learning is reset. When learning is reset,
all secure addresses on each port, within
the network, will be deleted and ports will
learn source addresses again.
CsEvFormat/Event000d113b
{d “%w- %d %m-, %Y - %T”} - Port
Group Learning Status is {T
LearnState 2} for the port group #{I 1}
of {m} ({t}). (event [{e}])
CsPCause/Prob000d113b
Port Group Learn State
This alarm is generated when a port
group’s learning is reset. When learning is
reset, all secure addresses on each port,
within a port group, will be deleted and
ports will learn source addresses again.
Table 4-1. CyberSWITCH 200 Series and 400 Events and Alarms (Continued)
Message in the Event Log
Alarm Manager Probable Cause
Message