Specifications

SPECTRUM Software Release Notice (SSRN)
For SPECTRUM 6.5.1
Page 90
Document 0743
Revision 14
June 2002
7 You may have difficulty creating and
removing Permanent Virtual Circuits
(PVCs) and Permanent Virtual Paths
(PVPs) from SmartCell 9A656-04 and
9A686-04 devices.
Use the Virtual Channel views available
for your device to create PVCs, and the
Virtual Path views to create PVPs. The
creation procedures are the same.
Creating a PVC involves defining
individual links (VPI/VCI) on each of two
ports and then cross-connecting the
ports. Use a Virtual Channel Link view to
define the links on each port and then
use a Cross Connect view to cross
connect the ports. Before you begin,
ensure that you have write privileges for
the device, set the proper traffic
parameters for the ports, and set the
ILMI parameters using local
management.
8 The graph in the ATM Performance view
may seem to display information
incorrectly. For example, the Log and Lin
(Linear) graphs may appear to show
100% of capacity when the cell rate
exceeds a certain value.
This happens when the graph is used to
show both percentages and rates, and
has a limitation on the total cell rate the
graph can show. Percentages cannot
exceed 100% and the rates have a
multiplier associated with them (noted
by an asterisk next to the attribute).
When the cell rate exceeds the graph’s
ability to show actual values, the % line
appears flat on the graph. The actual
tick-for-tick value of the rate is shown in
the table beside the graph.
9 The 9H531-18 devices running firmware
01.07.11 model as 9H532_18 models.
The 9H531-18 and 9H532-18 devices
use the same sysObjectID attribute. This
is a firmware issue.
Known Anomalies: SmartSwitch 9000/9500
Item Description Solution