Specifications

SPECTRUM Software Release Notice (SSRN)
For SPECTRUM 6.5.1
Page 94
Document 0743
Revision 14
June 2002
Cisco Catalyst
Management Module Information
MM Part Number Device(s) Firmware Version
SM-CAT1000 SwCat 1200 4.1, 4.21
SM-CAT1001 HubCat 1400 1.5
SM-CAT1002 HubCat 5xxx 2.1
SM-CAT1008 Catalyst 85xx NA
Known Anomalies
Item Description Solution
1 The HubCat5000 and HubCat5500
Interface Translation tables show only
Interface Index 1.
This is a firmware issue.
2 If you model the HubCat5000, open the
Interface Device or Device Topology
view, and then exit after the ports
configure, multiple lines of the following
message appear:
CsDIEnumText: No match for
Enumerated Value 268836429
This is a firmware issue.
3 For SwCat1200 models, clicking either
the Clear MAC or Clear Ports button in
the CATStackApp model’s Configuration
view causes a SpectroGRAPH error
message to display.
Use the read/write Community Name
when modeling the device. This clears
and sets all MAC and port counter
attribute values to zero when you click
the Clear Mac or Clear Ports button.
4 In the Device Topology view of the
SwCat5505, reconfigured (swapped)
boards appear in incorrect numeric
order.
This is a firmware issue. The port
information is correct. SPECTRUM reads
the incorrect CATStackMib MIB values
and cannot reorganize or update the
interfaces in a logical order.
5 The Catalyst 8500 model does not
display CAT_IF_Ports.
The device does not support the CISCO-
STACK-MIB.