Installation guide

Installation Guidelines
CSX200 Installation Guide 4-3
Figure 4-1 Removing the Plastic Chassis Cover
Installing a WPIM
To install a WPIM into the CSX200, refer to Figure 4-2 on the following page.
!
CAUTION
Before performing installation procedures, ensure that the requirements outlined in the
section, Tabletop and Shelf Installations on page 4-6, are met.
!
CAUTION
When removing an existing WPIM, make sure to pull the module straight out to avoid
damaging the connector.
Chassis Cover
Chassis
979-01
Cover Screw (1)