User`s guide

General Configuration Using Local Management
CSX200 Family User’s Guide 127
IPX RIP — Use this field to access the IPX RIP screen and enable Routing Information Protocol
(RIP) routing on the CSX200.
IPX General Configuration Screen
The IPX General Configuration screen allows you to configure the CSX200 for IPX routing.
Access the IPX Genral Configuration screen by using the arrow keys to highlight the
IPX General Config menu item and pressing ENTER. The IPX General Configuration screen,
shown in Figure 60, displays.
Figure 60 IPX General Configuration Screen
IPX General Configuration Status Fields
The following list describes each of the IPX General Configuration screen status fields. The status
fields are for informational purposes only and cannot be modified.
Router Name — Displays the type of routing used.
Status — Displays the status of IP Routing.
UpTime — Displays the amount of time elapsed since the last time the CSX200 was rebooted.
Router Name: IPX
IPX Routing:ENABLED
UpTime: 0 days 0 hours 39 min
SAVE RETURN
IPX General Configuration
Version: XX.XX.XX
Status: Enabled
AdminStatusTime: 0 days 0 hours 39 min
System Level Setup
Port Level Setup
Port: 1
MAC Address: 00-00-1D-22-46-B0
Oper Status: Enabled
Description: Ctron CSX200 EnetPort
Interf. Type: ethernet-csmacd
Framing: Novell
MTU: 1500
IPX Address: 0.0.0.0
IPX Forwarding: DISABLED
+PORT-
IPX Routing: DISABLED
CSX 200 Local Management Flash Image Version XX.XX.XX