User`s guide

Installation
CSX200 Family User’s Guide 27
To remove the chassis cover, proceed as follows:
1. Disconnect the CSX200 from the network as follows:
a. Unplug the power cord from the rear of the CSX200 chassis.
b. Disconnect all network cables attached to the CSX200.
2. Use a flat-blade screwdriver to remove the cover screw attaching the cover to the CSX200
chassis (refer to Figure 4) and save the screw.
3. Remove the cover by sliding it back until it clears the front of the chassis and then lifting it
straight up and off the chassis.
Figure 4 Removing the Plastic Chassis Cover
TIP
Before performing step b, mark any cables connected to the CSX200 according to their
associated port numbers. This is recommended for ease of reinstallation.
Chassis Cover
Chassis
979-01
Cover Screw (1)