Ethernet Network Adapter Installation Guide

Page 2-16
INSTALLATION
• The adapters use shared memory. VGA adapters will use the
A block through C7FFF. Memory adapters will use the entire
D block. If you don’t have a memory adapter installed, the D
block is your best selection - otherwise the C8000 starting
address can be used on the standard memory adapters.
• If Windows is installed on an Ethernet client, then it is
necessary to modify the SYSTEM.INI File. See the Network
Software Installation Guide.
• When using the packet driver version 4.0 or above, you must
use IPX (NSHPD) LAN Option 1.05.03 or above.
• If you are using a Kingston Memory Board, DO NOT use
automatic configuration after copying the Cabletron ADF file.
2.12 GETTING HELP
If you need additional support related to the adapter, or if you
have any questions, comments, or suggestions concerning this
manual, contact Cabletron Systems Technical Support. Before
calling, please have the following information available for use by
the Cabletron Technical Support personnel who will assist you.
• The Adapter type and Serial Number (i.e., E2112,
E1192070111).
• The software version that appears on the front of the installer
diskettes (i.e., E2100 Version 3.10.00, Rev. XX, P/N 2160251).
• Your computer make, model, and CPU type (i.e., IBM PS/2
Model XX, Intel 80X86, etc.).
• The operating systems and versions you are using (i.e., MS
DOS Version 5.0, and Novell NetWare Version 3.11).
• The make and model of any other add-in adapters you are
using in your system and their bus address, interrupt settings,
and memory allocation.