Ethernet Network Adapter Installation Guide

FCC NOTICE

This device complies with Part 15 of FCC rules. Operation is subject

to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

WARNING: This equipment has been tested and found to comply

with the limits for a Class A digital device, pursuant to Part 15 of FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a

commercial environment. This equipment uses, generates, and can

radiate radio frequency energy and if not installed in accordance with

the operator’s manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is

likely to cause interference in which case the user will be required at

his own expense to correct the interference.

If this equipment does cause interference to radio or television, which

can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

• Re-orient the receiving antenna.

• Relocate the computer with respect to the antenna.

• Move the computer away from the receiver.

• Plug the computer into a different outlet so that the computer

and the receiver are on different branch circuits.

If necessary, the user should consult the dealer or an experienced

radio/television technician for additional suggestions. The user may

find the following booklet prepared by the Federal Communication

Commission helpful:

“Interference Handbook”

This booklet is available from the U.S. Government Printing Office,

Washington D.C. 20402 - Stock No. 004-000-00482-5.