Setup guide

Page 3-1
CHAPTER 3
MMAC-M8FNB SETUP
This chapter contains instructions to help you set up Cabletron
Systems’ MMAC-M8FNB. You will not need any special tools or
equipment to set up the MMAC-M8FNB, but you must follow all
guidelines listed in Chapter 2, Installation Requirements and
Specifications.
3.1 UNPACKING THE MMAC-M8FNB
Before you install the MMAC-M8FNB, you should inspect the unit.
To unpack the MMAC-M8FNB:
1. Remove the MMAC-M8FNB and fan tray from the shipping box.
Save the shipping box and materials in the event the
MMAC-M8FNB has to be reshipped.
2. Slide the two foam end caps off the MMAC-M8FNB, and remove
the unit from the protective plastic bag. Set the MMAC-M8FNB
aside in a safe place.
3. Remove the accessory package and verify that it contains two
mounting brackets, a cable tie tray, and two security bars.
Contact Cabletron Systems Technical Support immediately if any
discrepancy exists.
Only qualified personnel should install or service this
unit and its modules.