Setup guide

MMAC-M8FNB SETUP
Page 3-4
3.2.2 Rack Mounting the Cable Tie Tray
A cable tie tray is provided with the MMAC-M8FNB to support and
organize cables connected to the unit. The tray is designed to be
installed under the MMAC-M8FNB in the equipment rack. To mount
the cable tray in a standard 19" equipment rack:
1. Slide the cable tie tray (Figure 3-2) into the rack.
2. Align the slots on each mounting bracket on the tray with the
desired holes on the equipment rack.
3. Insert a bolt through the slots in each of the mounting brackets and
into the threaded holes in the equipment rack. Use nuts with
locking washers to secure the bolts.
4. Tighten the nuts and bolts until the tray is secured to the rack.
Figure 3-2. Cable Tie Tray Installation
MMAC-M8FNB
The Complete Networking Solution™
Multi Media Access Center