EMM-E6 Ethernet User's Guide

CHAPTER 7: CONFIGURATION SCREEN
7-2 EMM-E6 User’s Guide
7.2 CONFIGURATION SCREEN FIELDS
The following briefly explains each Configuration Screen field.
I/F
Displays the interface number (1 to 6) corresponding to a particular
EMM-E6 channel. This number allows the EMM-E6 to accurately
identify MIB II channel information. The following table illustrates the
I/F number to channel association.
Channel A is the original Ethernet bus channel. Channels B & C are the
Flexible Network Bus (FNB) channels. Channel D is an external Ethernet
network accessed through an Ethernet Port Interface Module (EPIM).
Channels E and F are external connections through optional BRIMs.
Refer to Chapter 1 of this User’s Guide for a more complete description
of channels.
IP Address
Displays the IP address for each interface of the EMM-E6. This IP
address will be used for the sending and receiving of SNMP data and
should be configured for the interface with a connection to the network
management station. If the network management station is located on a
different network or subnet, the Default Interface and Default Gateway
must be properly configured to allow the proper functioning of SNMP
management.
I/F Channel
1A
2B
3C
4D
5E
6F
Channel E and F configuration options are dynamic. This
means the EMM-E6 only provides options for Channels E or
F if you have a BRIM module installed in one of these slots.
NOTE
CH1Book Page 2 Wednesday, March 20, 1996 7:48 AM