EMM-E6 Ethernet User's Guide

CHAPTER 7: CONFIGURATION SCREEN
7-4 EMM-E6 User’s Guide
7.3 SETTING THE HOST IP ADDRESS
The table on the Configuration screen allows you to assign an IP address
and Subnet Mask to the EMM-E6.
To set the Host IP:
1. Use the arrow keys to highlight the IP Address field.
2. Enter the IP address into this field. The format for this entry is
XXX.XXX.XXX.XXX, with values for XXX ranging from 0 to 254.
The EMM-E6 rejects non-numerics, adjacent dots (periods), or an
entry without dots separating the four XXX values.
3. Press the Return key. The screen displays the Host IP address and
changes any existing Subnet Mask to the default Subnet Mask for the
IP address entered.
4. Use the arrow keys to highlight the SAVE IPs command.
5. Press the Return Key. At the resulting prompt, typing “Y” will cause
the EMM-E6 to reset and load the Host IP changes into NVRAM.
If you exit the Configuration Screen without saving, you lose all edits.
The Host IP applies to each interface.
NOTE
It takes approximately 35 seconds for the EMM-E6 to save
and reset. The board is inoperable during this time. After the
EMM-E6 resets, the password screen appears and you must
re-enter Local Management.
NOTE
CH1Book Page 4 Wednesday, March 20, 1996 7:48 AM