EMM-E6 Ethernet User's Guide

MIB NAVIGATOR COMMAND SET OVERVIEW
EMM-E6 User’s Guide 13-11
13.3.3 Built-In Commands
The following provides a brief description, the proper format, and an
example of each Built-In command.
arp
The arp command provides access to the ARP (Address
Resolution Protocol) cache, enabling you to view cache
data, delete entries, or add a static route. Superuser access
is required to delete an entry or add a static route.
Each arp cache entry lists: the network
interface that the
device is connected to, the device’s
network address or IP
address, the device’s
physical address or MAC address, and
the
media type of connection to the device. The device’s
media connection occurs in one of the following ways:
1 - Other
2 - Invalid entry (cannot ping device, timed out, etc.)
3 - Dynamic route entry
4 - Static route entry (not subject to change).
Format arp -a (to view cache data)
arp -d <INTERFACENUM>
<IPADDRESS> (deletes an IP address
entry)
arp -s <INTERFACENUM>
<IPADDRESS> <MACADDR> (adds a
static entry)
Example MIBNav> arp -a
# Interface Network Address Physical Address Media Type
# (SonicInt) 122.144.40.111 00.00.0e.12.3c.04 3(dynamic)
# (SonicInt) 122.144.48.109
00.00.0e.f3.3d.14 3(dynamic)
# (SonicInt) 122.144.52.68 00.00.0e.12.3c.04 3(dynamic)
# (SonicInt) 122.144.21.43 00.00.0e.03.1d.3c
3(dynamic)
Example MIBNav> arp -d 1 122.144.52.68
Example MIBNav> arp -s 1 22.44.2.3 00:00:0e:03:1d:3c
CH1Book Page 11 Wednesday, March 20, 1996 7:48 AM