EMM-E6 Ethernet User's Guide

CHAPTER 1: INTRODUCTION
1-6 EMM-E6 User’s Guide
• BRIM-E6 : Ethernet module with selectable EPIM connection
•
CRBRIM-W/E-IP : Cisco Router Ethernet/Wide Area module for
TCP/IP traffic.
•
CRBRIM-W/E-DESKTOP : Cisco Router Ethernet/Wide Area
module for IP, IPX, DECNet, and AppleTalk traffic.
• CRBRIM-W/E-ENT: Cisco Router Ethernet/Wide Area module
for all standard Cisco protocols.
• BRIM-F0: 100 Mbps FDDI Dual Attached Station (DAS) Media
Interface Connector (MIC) connection for multimode fiber optic
media.
• BRIM-F5: 100 Mbps FDDI DAS MIC connection for single mode
fiber optic media
• BRIM-F6: 100 Mbps FDDI Dual Attach Station connection with
configurable connectors
The BRIM-F6 uses FDDI Port Interface Modules (FPIMs). The FPIMs
allow a media flexibility for FDDI connections by providing connector
and media types meeting several ANSI standards. The following FPIM
types are currently available:
• FPIM- 00: MultiMode Fiber - Physical Media Dependant
(MMF-PMD) compliant multimode fiber optic MIC connector
• FPIM- 02: Twisted Pair - Physical Media Dependant (TP-PMD)
complaint Unshielded Twisted Pair RJ45 connector
• FPIM- 04: TP-PMD compliant Shielded Twisted Pair RJ45
connector.
• FPIM- 05: Single Mode Fiber - Physical Media Dependant
(SMF-PMD) compliant single mode fiber optic MIC connector.
All CRBRIM-W/E products provide two WAN interfaces and one
internally connected Ethernet interface. The Ethernet connection is
provided through the use of an EPIM-3PS, which is included with
the purchase of the CRBRIM-W/E product.
NOTE
CH1Book Page 6 Wednesday, March 20, 1996 7:48 AM