EMM-E6 Ethernet User's Guide

BRIDGING
EMM-E6 User's Guide B-11
B.6 BRIDGING
The following OID is used to enable and disable the interface for the
bridging function.
dot1dstpPortEnable
Description: The enabled/disabled status of the port.
Object Identifier: 1.3.6.1.2.1.17.2.15.1.4
Data Type: Integer
Values: 1 enable
2 disable
Access Policy: read-write
B.7 TRUNK PORT SECURITY
The following OID is required if security is not desired on a trunk port.
The user must force the port to be a trunk port before locking the port via
the module or channel. Failing to do this will cause the port to become
locked out when the third address is seen on the trunk port.
rptrPortSrcAddrForceTrunk
Description: When this object is set to Force, it places the port
into a Trunk topology state whether or not the network traffic
warrants such a state. When this object is set to NoForce, it allows
the port to assume the topological state it would naturally assume
based on the network activity across it. When read, this object
reports the current setting.
Object Identifier: 1.3.6.1.4.1.52.4.1.1.1.4.3.5.1.4
Data Type: Integer
Values: 1 NoForce
2 Force
Access Policy: read-write
CH1Book Page 11 Wednesday, March 20, 1996 7:48 AM