EMM-E6 Ethernet User's Guide

CHAPTER 3: INSTALLATION
3-2 EMM-E6 User’s Guide
3.1 UNPACKING THE EMM-E6
Unpack the EMM-E6 as follows:
1. Remove the shipping material covering the EMM-E6.
2. Verify the contents of the packing carton. The carton is shipped with
the following items:
3. Carefully remove the module from the shipping box. Leave the
module in its non-conductive bag until you are ready to install it.
4. Visually inspect the module. If there are any signs of damage, contact
Cabletron Systems Technical Support immediately.
5. Place the static grounding strap properly on your wrist before opening
the non-conductive bag.
6. Open the non-conductive bag by tearing the black and yellow tape
seal.
7. Perform a second visual inspection of the module.
Item Quantity
EMM-E6 1
Firmware Image 1
Grounding Strap 1
RJ45 Adapter Kit 1
Release Notes 1
Observe all anti-static precautions when handling
sensitive electronic equipment.
!
CAUTION
Do not cut the bag open, as damage to the module could
occur.
!
CAUTION
CH1Book Page 2 Wednesday, March 20, 1996 7:48 AM