EMM-E6 Ethernet User's Guide

CHAPTER 3: INSTALLATION
3-18 EMM-E6 User’s Guide
3.9 CONNECTING TO THE NETWORK
This section gives procedures for connecting the EMM-E6 to the network
using the various EPIMs available. When the EMM-E6 is first powered up,
the EPIM 1 port acts as the bridge port and the EPIM 2 port is OFF.
Once you have successfully powered up your EMM-E6, you can add
network connections. The procedure for connecting Ethernet segments to
a hub varies depending on the media and ports you connect. Refer to the
following list and perform the procedure described in the subsection(s)
that apply to your hub:
• EPIM-T 3.9.1
• EPIM-X 3.9.2
• EPIM-F1,F2,F3 3.9.3
• EPIM-C 3.9.4
• EPIM-A 3.9.5
CH1Book Page 18 Wednesday, March 20, 1996 7:48 AM