EMM-E6 Ethernet User's Guide

CHAPTER 4: ATTACHING A CONSOLE
4-4 EMM-E6 User’s Guide
4.2.1 Connecting to a VT Series Terminal
To connect a VT Series terminal to a Cabletron module Console port
(Figure 4-1):
1. Connect the RJ45 connector at one end of the cable to the Console port
on the Cabletron module.
2. Plug the RJ45 connector at the other end of the cable into the RJ45 to
DB25 female adapter.
3. Connect the DB25 adapter to the port labeled COMM on the VT
terminal.
Figure 4-1. Connecting a VT Series Terminal
4. Turn on the terminal and access the Setup Directory. Follow the
directions in the previous section and set up your VT terminal to match
the configuration given in Table 4-1.
5. When these parameters are set, the Local Management password
screen will appear. Refer to Chapter 5, Accessing Local Management.
VT S i T i l
CH1Book Page 4 Wednesday, March 20, 1996 7:48 AM