Owner manual

Power Supply Operation
Page 2 PN 9031984-01
Power Supply Operation
The ESX-1320R and the ESX-1380R are equipped with two load sharing power
supplies to provide redundancy. Two power cord outlets, labeled Power 1 and
Power 2 (see Figure 1), are used to provide power to each power supply. To take
advantage of the load sharing and redundancy capabilities, each power cord must
be plugged into a dedicated ac outlet.
LANVIEW Diagnostic LEDs
In addition to the LANVIEW LEDs located on the front panel of the ESX-1320
and the ESX-1380, the ESX-1320R and the ESX-1380R are equipped with two
LANVIEW diagnostic LEDs located on the rear of the unit (see Figure 1). These
LEDs provide an easy way to observe the status of the individual power supplies.
Table 1 provides a description of the LANVIEW power supply LEDs.
Physical Properties (ESX-1320R or ESX-1380R)
Dimensions: 6.86H x 43.18W x 46.99D (cm)
2.7H x 17W x 18.5D (in)
Weight (Unit): 5.45 kg (12 lb)
Electrical Specifications (ESX-1320R or ESX-1380R)
Input: 100-125 V ~ /4.0 A
200-250 V ~ / 2.0 A
Phasing: Single-phase
Frequency: 50/60 Hz
Table 1 LANVIEW Power Supply LEDs
LED Color Description
PWR 1
Green Power Supply 1 is operating correctly.
Red Power Supply 1 is not operational.
PWR 2
Green Power Supply 2 is operating correctly.
Red Power Supply 2 is not operational.