User`s guide

Filling Out a Case
Developing the Case Library SpectroRx (SPECTRUM Resolution Expert)
3-8 User’s Guide 5.0rev1
Filling Out a Case
Follow these steps to create a case for the SpectroRx case library.
1. Open SpectroRx.
Follow the steps in the section Accessing SpectroRx from SPECTRUM in
Chapter 2.
The SpectroRx window appears. This window includes specific
information about the alarm that you selected in SPECTRUM Alarm
View.
2. Enter the appropriate information in the fields. See the section Case Field
Requirements in this chapter for details about each field.
SpectroRx is not case-sensitive so it does not matter if you use lower or
uppercase letters.
3. Select the Save Case option or button to save the case to the case library.
When you save the new (unnumbered) case, SpectroRx assigns a number
to the case and enters the information in the database.
4. If you do not have the time or information to complete all the fields, jot
down the number of the case after you save it, then open the case later
and fill out the fields.
The section Editing an Existing Case later in this chapter describes these
procedures.
Figure 3-2 contains a completed case.
NOTE
If you are in a multi-user system and someone else is saving or deleting a
case at this time, you will get a message saying “SpectroRx is in use.
Please try again.” If you constantly get this message, the case library file
could be locked from a system crash. To correct the problem, go to the
< SpectroRx > directory (the directory that contains the case libraries)
and remove the file in_use .