User guide

Displaying Trunking Status
Fast Network 100 User Guide Page 3-9
The following conditions can be displayed:
• Closed (or Oneway) — Trunking is enabled, and the Trunking
Protocol is attempting to establish a trunk connection.
• Heldown — Trunking is enabled, but the trunk connection was
rejected. After a short time-out period, another attempt is
automatically initiated to establish a good trunk connection.
• Joined — Trunking is enabled, and the Trunking Protocol has
established a good trunk connection.
• Off — Trunking is not enabled.
• Perturbed — Trunking is enabled, and a good trunk connection has
been established. However, the forwarding of data packets is
temporarily suspended to allow for a change in the membership of the
Trunk Group.
Use the
status <PORTS> command to check the status for ports configured
for trunking.
FN100 > status 1
LCM responds:
Port 1 Status
Bridging: Transparent Bridging
Enabled/Disabled: Enabled, Rip listening
Spanning Tree: Forwarding
Trunking State: Off
Speed: auto (10)
Virtual Switch: Sw1
Work Group: (None)
Hardware State: Up
Pkts Transmitted: 215119
Pkts Received: 179539521
Link Status: Up (1 outage)
Total Collisions: 1492
Excess Collisions: 0
RX Missed Pkts: 0
RX Dropped Mgmt Pkts: 0
RX CRC/Align Errs: 0
Internal RX Errs: 0
Internal TX Errs: 0