User guide

Defining and Deleting Workgroups
Fast Network 100 User Guide Page 3-13
Use the workgroup <NAME> <PORTS> command to create or modify the port
list for a specific workgroup. For example:
FN100 > workgroup a 2-6
Figure 3-2 shows the FN100 with two defined workgroups (A and B).
Workgroup A uses ports 1 through 3, and workgroup B uses ports 5 and 7.
Port 11 connects a segment that contains both workgroup A and
workgroup B hosts:
Figure 3-2 Defining Workgroups
The LCM commands used to create the above configuration are as
follows:
1. To create workgroup A on ports 1, 2, 3, 11, and 12:
FN100 > workgroup A 1-3,11,12
FN100
B
B
AB
Workgroup A
Workgroup B
100 Mbps
100 Mbps
B
Router
A
A
A
B
B
A
A