User`s guide

A-1
Appendix A
Helpful Hints for Configuring
SmartTrunk
1. Navigate through Local Management to the SmartTrunking ConÞguration
Screen.
2. Using the arrow keys, move the cursor to the Add/Remove Group Þeld.
3. Type the name of the SmartTrunk group you wish to create.
4. Highlight the SAVE command, and then press the Return key.
5. Using the arrow keys, move the cursor to the Port Þeld.
6. Select the port that is to become part of the SmartTrunk Group just created.
Press the Spacebar to change the port number.
7. Using the arrow keys, highlight the ADD Þeld, and then press the Return key.
The port and state will be added to the table on the trunking page.
The port will no longer show in the list of ports that can be added.
8. Repeat steps 5 through 7 to select the next port to be added. If the ports to be
added to the group are sequential, start by selecting the lowest port value and
continue to press the Return key while on the ADD Þeld. The ports will
increment automatically as you press Return.
This procedure must be completed on both switches participating in Trunking.
NOTE
The group must be created and saved prior to adding ports to the group.
NOTE