Specifications

Using the RESET Button

4-10 Troubleshooting

4.3 USING THE RESET BUTTON

The RESET button, located near the upper plastic locking tab of the module (refer to Figure 4-2),

resets the 6E233-49 SmartSwitch processor without affecting the NVRAM.

Figure 4-2 RESET Button

To reset the 6E233-49 SmartSwitch processor, press and release the RESET button. The module

processor goes through a reset process of approximately 20 seconds. Additional downtime may be

added as the module reenters the network.

CAUTION

Pressing the RESET button resets the device, and all current switching being

performed by the module is halted. A module downtime of up to two minutes

results from this action.

NOTE

It is not recommended to press the RESET button while the module is already in

reset mode. The module will enter an extended diagnostic procedure, which is

unnecessary for normal operation. This procedure will take much longer than a

minute. The ESC key can be used to exit the procedure.

3612

ETHERNET

6E233-49

RESET

COM

CPU

26931_10

RESET

Button

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com