User manual

Talkwire Operation
80-10100000-09 7–3
ACTIVE indicates that the facility is in use (backup is in progress, or
remote diagnostics are initiated).
7.3 Initiating a Talkwire Call
Let us assume that TALKWIRE is set to ON for both channels of your
KBU 64 and that the USER ports are connected to the Kilostream lines
(for data transmission), also the CONNECT parameter is set to MAN.
At the channel prompt from which you wish to initiate the call (1 or 2),
type:
1> DIAL xxxxxxx/yyyyy[CR]
where:
xxxxxxx is the ISDN line number of the remote unit
and
yyyyy is the ISDN sub-address number of the remote unit (if sub-
addressing is used).
Providing that the link is successfully completed, the messages
displayed at the local terminal will read:
1: DIALLING xxxxxxx
1: RINGING
1: ONLINE
1: TALKWIRE ACTIVE (V2+)
During this dialling sequence, the terminal operator of the remote KBU
64 will be notified of the incoming call, and the ISDN channel of his KBU
on which the call is being received.
In our example the call was placed from channel 1 of the local KBU 64 to
the ISDN number of channel 2 of the remote unit, you would see:
2: INCOMING CALL xxxxxxx
2: ANSWERING
2: ONLINE
2: TALKWIRE ACTIVE (V2+)