User manual

Configuration Commands
80-10100000-09 4–3
For example:
1> SET BACKUP AUTO[CR]
Where:
Syntax Function
1>
The command line prompt for the Kilostream Channel 1.
(The > is the channel suffix, 1> - Channel 1, >2 -
Channel 2. Responses from the unit (such as error
messages) are identified by: (colon), i.e. 1:, 2: )
SET
The command prefix used to prepare your KBU 64 for a
configuration command (see section 4.5).
BACKUP
is the primary command indicating which parameter you
will alter the configuration setting of.
AUTO
is the secondary command (the new configuration
setting).
You can only issue one primary command on a single line, issuing
multiple primary commands within a single line will return an error
message.