User manual

KBU 64
User Manual
80-10100000-094–4
4.3 Active Channel Command
Alters the active channel reference (the active channel is the channel
which will be effected by all subsequent configuration commands).
The command line prompt indicates which of the channels is active:
1>
indicates that B1 (channel using the LINK 1/USER 1
connectors on your KBU 64) is currently the active channel
for commands
2>
indicates that B2 (channel using the LINK 2/USER 2
connectors on your KBU 64) is currently the active channel
for commands.
To alter the active channel enter ‘1’ or ‘2’ followed by [CR] i.e.:
1> 2[CR] alters the active channel from B1 to B2.
4.4 Default Configuration
Your KBU 64 has been shipped with factory default settings for each of
the configuration options.
To display a status screen showing the current configuration settings for
both the B1 and B2 channels, at the command line prompt, type:
1> STATUS[CR]
Note that as well as detailing your KBU 64 configuration settings, an
activity status report on the ISDN and Kilostream lines is also displayed
together with an indicator showing to which of these the USER interface
is currently connected.