User manual

KBU 64
User Manual
80-10100000-094–8
This system day will be implemented as soon as you have pressed the
carriage return key, terminating the command line.
4.7.1 Viewing the Current System Time, Date and Day
The current system time, date or day can be viewed by typing:
1> TIME[CR]
1> DATE[CR]
1> DAY[CR]
as required.
4.8 Defining the Line Characteristics
To enable compatibility with your DTE and Kilostream line operation, the
actual line speed and data protocol of each of your USER ports
(channels 1 and 2) must be correctly configured within the KBU 64.
The default settings for both channels 1 and 2 are set to operate
synchronously at 64Kbit/s.
4.8.1 Altering the ISDN Line Protocol Definition
To see the current protocol setting of both channels of your KBU 64,
issue the STATUS[CR] command at the command line prompt. Normally
data protocol for traffic on both channels will be synchronous.
If the requirement for either of your DTEs is for asynchronous data, you
must alter your KBU 64’s configuration to reflect this.
Note that it may first be necessary to change the SPEED parameter to a
speed which can be both synchronous and asynchronous (600 to
38k4bit/s), otherwise the asynchronous DATA setting parameter change
will not be accepted by the KBU 64.