User manual

Configuration Commands
80-10100000-09 4–9
To alter the protocol setting of B1 (USER 1 to LINK 1):
1> SET DATA dddd[CR]
where:
dddd
is either SYNC or ASYNC.
To alter the protocol setting of B2 (USER 2 to LINK 2), change the active
channel from 1 to 2 (type 2[CR]) and repeat the previous command
string.
4.8.2 Altering the ISDN Speed Definition - Rate Adaptation
To display the line speed of the active channel type:
1> SPEED[CR]
1:B1 data rate – 64K
If the data rate of either of your DTE ports (connected to LINK1, and
USER 2) differs from that of your KBU 64’s configuration, the
configuration must be altered to reflect the actual speed.
To alter the line speed of B1 (USER 1 to LINK 1):
1> SET SPEED sss[CR]
where:
sss
is the speed of your DTE port.