User manual

KBU 64
User Manual
80-10100000-094–24
1> SET ANSWER xx[CR]
where
xx
is AUTO, MAN or CLID
Answering an incoming call on the ISDN does not route the data path
away from the Kilostream line. It is only used to set up the ISDN call.
The current setting of the ANSWER command can be viewed on the
KBU 64’s STATUS[CR] screen.
4.13.5 Configuring the Calling Line Identification Table
This feature enables you to save up to 99 (1 to 99) Calling Line
Identification Numbers, for each of the two channels, in numbered store
locations of your KBU 64.
If the ANSWER parameter of your KBU 64 is set to CLID, only calls from
KBU 64s whose originating number matches one of those held in your
KBU numbered store locations will be answered.
This provides a security feature within your network, ensuring a rogue
call cannot connect to your ISDN line (This is normally an option which
must be requested from the ISDN service provider).
1> SET CLID yy xxxx[CR]
where
yy
is the store location in which the CLID
number is to be held (1-99)
xxxx
is the telephone number of the remote KBU
64 that is able to place an ISDN call to your
unit.