User manual

Configuration Commands
80-10100000-09 4–31
Note: The time delays between an unsuccessful dial attempt and the next
dial attempt, and that between the end and beginning of a cycle are
user configured, as detailed in sections 4.15.13 and 4.15.14
.
4.15 Configuring the Delay Timers
The SET DELAY command is used to configure the delay time (in
seconds) settings for backup, restoral, Talkwire and Alarm commands.
The factory defaults are:
1> DELAY[CR]
chan 1
chan 2
ANSWER 3 3
BACKUP 3 3
RESTORE 3 3
CONNECT 3 3
DISCONNECT 3 3
TALKWIRE 5 5
ALARM 0 0
NTU 0 0
CLOCKLOSS 1 1
ALERT 0 0
TWDATA 3 3
DATALOSS 0 0
DIAL 1 1
REDIAL 1 1
PASSWORD 60 60
1> _
4.15.1 ANSWER Timer
When ANSWER has been set to AUTO, you can define the delay period
before your KBU 64 will answer an incoming call:
1> SET DELAY ANSWER xxx[CR]
where
xxx
is the time in seconds (0 to 999).