User manual

Configuration Commands
80-10100000-09 4–37
4.16 Verifying the ISDN Line
The VERIFY command will initiate a test of the line using both channels;
providing Talkwire is enabled for both channels (see section 7), and
STORE directory location 1 has been configured to contain the
telephone number of your backup line.
Type: 1> VERIFY[CR]
to initiate a test of both channels of your ISDN link.
4.16.1 Automatically Testing the ISDN Line
The ISDNTEST command is used to set a time when the backup number
will be dialled every day, providing Talkwire is enabled (see section 7),
and the line verified.
From the appropriate command line prompt, type:
1> SET ISDNTEST hh:mm[CR]
where
hh
represents the time of the test in hours
(using a 24 hour clock)
mm
is the number of minutes past the hour
To view the time at which the ISDN line will currently be tested, type:
1> ISDNTEST[CR]
To disable ISDNTEST, type:
1> SET ISDNTEST[CR]
4.17 FLASH Alarm LEDs
The FLASH command is used to select between flashing, or constantly
lit front panel ALARM LEDs:
1> SET FLASH xx[CR]
where
xx
is ON or OFF.