User manual

KBU 64
User Manual
80-10100000-096–2
6.2 Manually Initiated Backup to the ISDN Line
You can initiate Manual backup from the appropriate command line
prompt by issuing the BACKUP command.
1> BACKUP[CR]
In our example backup is initiated on channel 1, using the telephone
number stored in STORE directory location 1, to make a call over the
ISDN. If the call is unsuccessful, alternate redialling is initiated as
described in section 4.14. When the call has been answered, USER 1
port is connected to the ISDN line.
As an alternative, you can use a telephone number held within any
STORE directory location as the backup number by typing:
1> BACKUP Nn[CR]
where
n
is the STORE directory location of the required backup
telephone number.
As another alternative, any telephone number can be used in conjunction
with the BACKUP command, by fully specifying the number on the
backup command line i.e.:
1> BACKUP 07931234567[CR] or
1> BACKUP 07931234567/PORT1[CR]
if a sub-address is used.
6.3 Manually Dialling a Remote KBU 64
The DIAL command can be used to initiate a call over the ISDN to any
remote KBU 64. The command is functionally the same as the BACKUP
command, except that the KBU 64 will not automatically connect the
USER port to the ISDN line (unless CONNECT is set to AUTO).
1> DIAL[CR]
In our example, an ISDN call is initiated on channel 1, using the
telephone number stored in STORE directory location 1.