User`s guide

2-1
Chapter 2
Installing the 9G426-02 Module
This chapter describes the physical layout of the 9G426-02 Module and explains
how to prepare and install the module in an MMAC-Plus chassis.
The 9G426-02 module occupies a single slot in the MMAC-Plus chassis. Install the
9G426-02 module by following the steps starting below.
Unpacking the Module
1. Carefully remove the module from the shipping box. (Save the box and
packing materials in the event the module must be reshipped.)
2. Remove the module from the plastic bag. Observe all precautions to prevent
damage from Electrostatic Discharge (ESD).
3. Carefully examine the module, checking for damage. If any damage exists,
DO NOT install the module. Contact Cabletron Systems Technical Support
immediately.
Never expose the module’s components to Electrostatic Discharge. Make sure you have
attached the module’s disposable grounding strap to your wrist and always place the
module on a non-conductive surface.
!
CAUTION
The INB Terminator Modules must be installed on the rear of the chassis before powering
up this module. Refer to the INB Terminator Modules Installation Guide for
information and installation procedure.
NOTE