User`s guide

2-9
Installing the 9G426-02 Module
Installing the Module into the MMAC-Plus Chassis
To install the 9G426-02 Module into the MMAC-Plus Chassis, follow the steps
below:
1. Remove the blank panel covering the slot in which the module is being
installed. If you are only installing one module, make sure the chassis’ other
module slots are covered. This action ensures proper airflow and cooling.
2. Attach one end of the ESD wrist strap packaged with the MMAC-Plus chassis
to your wrist. Plug the other end into the ESD Wrist Strap Grounding
receptacle in the lower right corner of the MMAC-Plus Chassis shown in
Figure 2-5.
3. Grasp the module and slide it into the slot.
Make sure that the module’s circuit card is between the card guides, as shown
in Figure 2-5. Check both the upper and lower tracks of the card. Take care
that the module slides in straight and engages the backplane connectors
properly.
4. Lock down the top and bottom plastic tabs, as shown in Figure 2-5.
To insure proper data transmission from the 9G426-02 Module to the INB on the
MMAC-Plus backplane, two INB Terminator Modules must be installed on the rear of
the MMAC-Plus chassis . Refer to the INB Terminator Module Installation Guide
for information and installation procedure.
NOTE