User`s guide

When an icon representing a HubCSIMRXi is visible, follow this path
View -> Icon Subviews -> Model Information
to select the icon subview that controls polling and logging of attributes for the HubCSIMRXi devices.
For model
types other than HubCSIMRXi, use the Management Module Guide to determine which icon subview controls
polling and logging of attributes for your device.
Set the Poll Interval field to 60 to collect data every minute.
When changing the value for this field, you may be asked to confirm the changes. Select OK to keep the
changes.
Set the Log Ratio field to 10 to log data every ten minutes.
Select File and Close to exit from the Model Information icon subview.
SPECTRUM begins the polling and logging.
ii. Verify what is being logged.
Follow this path:
View
->
Icon Subviews
->
Model Information
and look at the LOGGED list box. The attributes that are now being logged display in this section.
Note: If the attributes listed do not describe the performance of the device sufficiently for your purposes, you
may need to edit the model type definition so that it logs other attributes in addition to the ones shown. See
Cabletron SPECTRUM Appendix 5: Editing Model Types for SPECTRUM
for information on adding attributes
to be logged.
iii. Repeat these steps for the remaining devices of type HubCSIMRXi for which you want to collect data.
Note: If you find this interactive method too time-consuming, see Cabletron SPECTRUM Appendix 2: Alternate
Data-Logging Method.
Note:
You can exit SpectroGRAPH now (by selecting
File
and
Exit
) without affecting data polling and logging.
e. Edit the export script.
The script that executes the actual data export process must be configured for your site.
i. Edit this file in any ASCII editor.
SPECTRUM_home/SG-Tools/dtxscript
ii. Delete the comment delimiters (#s) that are at the beginning of these lines:
# SASROOT=
# export SASROOT
iii. Specify the location of base SAS software.
SASROOT is the path to base SAS the lines to software. Add the SASROOT path to the line that now begins
SASROOT=. For example, change it to this: