Network Hardware User Manual

Link/Seg Traps
3-6 Enabling and Disabling Link/Seg Traps
2. Click mouse button 1 on ; the Port Traps window, Figure 3-4,
will appear.
Figure 3-4. The Port Traps Window
3. In the port traps window, click mouse button 1 to select the port or ports for
which you wish to configure traps. If the Set Trap Status For field displays
Selected Ports (the default setting), you can click to select any ports; to de-
select any highlighted port, click on it again. If the selection All Ports on
Module is displayed in the Set Trap Status For field, you can select only one
port at a time; trap status will be set for all ports on the same module as the
selected port. If the selection All Ports on Repeater is displayed in the Set
Trap Status For field, all available ports will be automatically selected; if you
de-select any port, the Set Trap Status For field will automatically revert to
the Selected Ports setting. To change the setting in the Set Trap Status For
field, click on the currently displayed setting, and drag down to select a new
setting.
4. Click on the appropriate selection in the Link Traps field to Enable or Disable
link traps for the selected modules, as desired.
5. Click on the appropriate selection in the Segmenting Traps field to Enable or
Disable segmenting traps, as desired.
6. Click on to save your changes; click on to exit the
window.