User guide

30 ELH100-12/24TX User Interface ELH100-12/24TX
Main Menu
The Main Menu is the first screen seen after successfully logging in to the
system. Figure 3-3 shows the Main Menu and the accompanying table
describes the Main Menu
.
Figure 3-3. Main Menu
Main Menu
=========
System Information ... Exit ...
Restart Hub ...
Configuration Screens
=====================
System Configuration ... TFTP Download ...
SNMP Configuration ... XMODEM Download ...
Hub Configuration ... User Password ...
Port Configuration ... Console Configuration ...
Statistics Screens
==================
Hub Statistics ... Port Statistics ...
Display or work with system information
Use <TAB> or cursor keys to move, <ENTER> to select
Selection Description
System Information Provides system description, including system name and other
data.
Restart Hub Performs a software reset of the management agent for all hubs
in stack or for a selected hub by restarting the system software
and reloading certain operating parameters.
Exit Logs out of the console interface. Once you log out, you must
enter a user name and password before you can access the
console interface again.
System Configuration Configures IP parameters, including address, subnet mask,
gateway, SLIP IP, default bootup IP. Specifies maximum
number of Telnet sessions. Specifies the SNMP agent’s
segment.
SNMP Configuration Configures communities and trap destinations.
Hub Configuration Displays hardware/firmware versions for hub, isolates/attaches
hub’s repeater segments, and shows if an Agent Module or
switch/media module is installed. If an Agent Module is
installed, shows its bootup option, MAC address, hardware/
firmware versions, and the Baud rate of the serial port.
Port Configuration Disables/enables any port; and sets communication mode to 10
or 100 Mbps, or auto-sensing.
TFTP Download Downloads new firmware version to update the Agent Module
over the network.