User guide

9033060 ELH100-12/24TX User Interface 41
Port Configuration Menu
Select Administrative Status Control from the Port Configuration screen,
then select the port group to configure, either “1 thru 12,” “13 thru 24,” or
“Switch/Media Module” (if installed). The following screens show the
configuration options.
Port Administrative Status Control Menu
Figure 3-11. Port Administrative Status Control Menu
Port Administrative Status Control (1 - 12)
===========================================
Hub ID: 1 Model: ELH100-12TX
Port Admin State Link State Auto Partitioned Mode Speed (Mb/s)
--- -------- ------- ----------- ---- -----------
1 Enabled No Link No Auto
2 Enabled No Link No Auto
3 Enabled No Link No Auto
4 Enabled No Link No Auto
5 Enabled No Link No Auto
6 Enabled No Link No Auto
7 Enabled No Link No Auto
8 Enabled No Link No Auto
9 Enabled No Link No Auto
10 Enabled No Link No Auto
11 Enabled No Link No Auto
12 Enabled Link No Auto 100
<APPLY> <OK> <CANCEL> <PREV_SCREEN> <NEXT_SCREEN>
Use the space bar to toggle states
Use <TAB> or cursor keys to move, <SPACE> to toggle, <ENTER> to select
Selection Description
Admin State Allows you to disable a port due to abnormal behavior such
as excessive collisions, and re-enable it after the problem
has been resolved. You may also disable a port for security
reasons.
Link State Indicates if the port has a valid connection to an external
device.
Auto Partitioned Indicates if the port is partitioned.
Mode Sets the transmission speed to 10 Mbps, 100 Mbps or auto-
detection.
Speed Indicates the transmission speed currently used by this port.