Specifications

2-10 SmartSwitch 6500 Reference Manual
Console Commands
ATMRoute
Use ATMRoute to manage routes to reachable addresses from the switch.
2p›F You can hot-swap TSMs. Hot-swapping is replacing a module when the chassis is
powered up. If you replace a TSM with another TSM of the same type (same I/O
ports), existing configuration of port parameters is not affected. This includes
parameters set using any of the following attributes: ATMRoute,
CACServiceClassBw, IlmiConfig, NetPrefix, Port, PortConfig, PVC, PVP,
ServiceRegistry, SigTimer, SigStatistics, SSCOPConfig, and SSCOPStatistics. If
you replace a TSM with another TSM of a different type, existing configuration
of port parameters is deleted. The deletion occurs when the new module is plugged
into the chassis backplane.
Operators
add, delete, show
Parameters
Input Parameter Description Value/Field Size Default
[Num] Index number of the route as assigned
by the console. Use the
show
atmroute all
command to get a list of
index numbers.
Positive integer All
[PortNumber] Port number on the switch. 1A1 to 8B4 (for physical ports),
1A1.n to 8B4.n (for virtual
ports), or All
All
[AtmAddr] Address prefix of the ATM end
system.
No default
[PrefixLength] Length in bits to apply to the address
prefix.
No default
[AddressIndex] Index into the set of listings of
connectivity to the address prefix.
0
[Type] Type of reachability from the switch to
the address prefix.
Exterior, Internal, Reject Internal