Setup guide

Chapter 3: 6C110 Setup
3-8 6C110 Overview and Setup Guide
3.7 INSTALLING THE POWER BRIDGE ADAPTER
This section provides instructions on installing the power bridge adapter
to allow the 6C110 chassis to support the 6C210-1 or 6C210-2 power
supplies. If the legacy 6C205-2 or 6C205-3 power supplies will be used
DO NOT install the power bridge adapter.
To install the power bridge adapter, perform the following steps:
1. Attach the ESD wrist strap. Refer to Section 3.5 for details.
2. Refer to Figure 3-6 to identify the front and rear sides of the power
bridge adapter.
Figure 3-6 Power Bridge Adapter (Front and Back)
3. Remove the three screws from the lower backplane, as shown in
Figure 3-7.
!
CAUTION
This section applies to users that will equip the 6C110 chassis
with 6C210-1 or 6C210-2 power supplies, and the 6C110
chassis has already had the power bridge adapter removed. If
legacy 6C205-2 or 6C205-3 power supplies will be used, DO
NOT install the power bridge adapter.
The three standoffs and the support clip removed from the
chassis in step 6 and step 8 of Section 3.6 are required to
install the power bridge adapter.
Power Bridge Adapter
(Front, White Connectors)
Power Bridge Adapter
(Rear, Black Connectors)