Setup guide

Installing the Power Bridge Adapter
6C110 Overview and Setup Guide 3-9
Figure 3-7 Removing the Screws
4. Using a .25-inch hex nut driver, install the three standoffs into the
holes that formerly held the screws removed in step 3. See Figure 3-9.
5. Install the support clip by sliding the notched end over the rear chassis
card cage, in the space provided next to the upper right hand corner of
the lower backplane. Refer to Figure 3-8 and Figure 3-9.
Figure 3-8 Installing the Support Clip
6C405
Upper Backplane
Lower Backplane
Screw
Screws(2)
Upper Right Hand Corner
of Lower Backplane
Chassis Card Cage
Back Panel
of Chassis
Side View of Installation
Chassis Card Cage
Support Clip
Back
Panel
of
Chassis
Front View of Support Clip Installation Location